Upgrade from 2.20 to 2.30

mbayard

Hi,

I upgraded from 2.20 to 2.30, everything went fine, but the Web Interface doesn't show the "Group by storage type" at the correct place, and the "New" buttons from "Reporter" section/tabs are not doing anything.

I tested on a fresh 2.30 and everything is fine ...

Upgraded :



Fresh Install :

Pavel

can you try it in some other browser?

It might be some browser caching issue.

mbayard

I'll slap myself, you're correct ... Other browser is fine, and ctrl-f5 in first browser is fine too now

Thanks again.

mbayard

While looking to this problem, I also noticed in reporter.error.log :

Thu May 24 15:44:30 2018: /home/stor2rrd/stor2rrd/etc/web_config/reporter.json does not exists! Exiting... : No such file or directory
Thu May 24 16:15:19 2018: /home/stor2rrd/stor2rrd/etc/web_config/reporter.json does not exists! Exiting... : No such file or directory
Thu May 24 17:15:17 2018: /home/stor2rrd/stor2rrd/etc/web_config/reporter.json does not exists! Exiting... : No such file or directory



which indeed is not where stor2rrd is installed ... dunno if it's important

Pavel

this file exists once reporter is configured.

We should suppress that message if there is no reproter cfg yet.

mbayard

Hi Pavel,

I think I filled everything in the "Reporter" tabs and the configuration was saved :



I created a report but when I tried to Save&Run :





My stor2rrd instance is not located in the homedir of the stor2rrd user, can this be an issue ?

Thanks.

Pavel

ok, this is a bug

to fix it:

vi bin/reporter.pl

remove line 13:

$basedir         = "/home/stor2rrd/stor2rrd";

Then it will work.

mbayard

It works now, thanks

mrcpld

Hi All
I have a problem with the update, after switching to 2.30, the tool continues to report an error on the asynchronous replicas between an SVC and V7000:

STOR2RRD FlashCopy Error for device v7000,
STOR2RRD FlashCopy Error for device svc,

Actually we do not have any anomaly but it's just a mistake of stor2rrd snapshot alerting system.

it's possible disable/exclude the Snapshot alerting in a specific storage?

Why does the system recognize this replication mode as an error?

Pavel

Hi,

cd /home/stor2rrd/stor2rrd

cat tmp/snapshotting-status/<storage name>.txt

You can even send it to our support email

http://www.stor2rrd.com/contact.htm?3.1