IBM FlashSystem 5200 ports drawing issue

Hello,

I've noticed recently that our stor2rrd server is drawing additional ports which don't exists in configuration for our FS 5200.

It has 2 nodes, each node one FC card and only 2 ports are used and cabled to the SAN. Below output from cli:

id fc_io_port_id port_id type port_speed node_id node_name WWPN           nportid status attachment cluster_use adapter_location adapter_port_id

0 1           1     fc 32Gb     1     node1   500507681211155D 652200 active switch   local_partner 1              1

1 2           2     fc 32Gb     1     node1   500507681212155D 662200 active switch   local_partner 1              2

24 1           1     fc 32Gb     3     node2   500507681211155E 652600 active switch   local_partner 1              1

25 2           2     fc 32Gb     3     node2   500507681212155E 662600 active switch   local_partner 1              2

In stor2rrd server in "data" folder, file port.cfg is correct:

$ cat PORT/port.cfg

node1_p01:(FC 500507681211155D)

node1_p02:(FC 500507681212155D)

node2_p01:(FC 500507681211155E)

node2_p02:(FC 500507681212155E)

But file ports.col is showing additional ports from p03 to p07 for each node,

and what's the worse it sees some traffic on _p03 for both and drawing it in GUI.

$ cat PORT/ports.col

0 : node1_p01 (FC 500507681211155D)

1 : node1_p02 (FC 500507681212155D)

2 : node1_p03

3 : node1_p04

4 : node1_p05

5 : node1_p06

6 : node1_p07

7 : node2_p01 (FC 500507681211155E)

8 : node2_p02 (FC 500507681212155E)

9 : node2_p03

10 : node2_p04

11 : node2_p05

12 : node2_p06

13 : node2_p07

I have already tried to delete this 5200 from stor2rrd configuration, delete all required folders and files,

then add it again to stor2rrd and rerun load.sh again. But it behaves the same , it still sees ports p03 to p07

and some traffic on p03.

We are running firmware Version: 8.5.0.6 , and model is 4662-6H2 .