connecting to eternus DX90

cja

I'm trying to connect to a Fujitsu eternus DX90 (quite old).
SSH-connect works fine and I can login via ssh as lpar2rrd (appliance).
When I do the config_check it's trying to do this: echo "show performance" | ssh ******
Well, it should work fine, but it doesn't. It seem's that the echo pipe doesn't work from here.
When I login via ssh from the appliance manually it works fine, I can start the show performance.

Maybe it's just a problem with the old firmware, but i cannot cross check this issue.
Any hints here?

Pavel

Hi,

do you use -tt parameter in ssh?

echo "show performance" | ssh -tt <host>

cja

yes, i do, or better said, stor2rrd is using it. 

STOR2RRD version

2.52

, latest appliance.

Eternus DX90
Model Name ET09E24AG

Firmware Version V10L72-0000

automatically via config_check.sh:

  TCP connection to "10.2.144.150" on port "22" is ok

echo "show performance" | ssh -o ConnectTimeout=80 -o StrictHostKeyChecking=no -o PreferredAuthentications=publickey -o SendEnv=no -q -tt lpar2rrd@10.2.144.150

  connection failed!!

manually:

[lpar2rrd@xorux stor2rrd]$ ssh -o ConnectTimeout=80 -o StrictHostKeyChecking=no -o PreferredAuthentications=publickey -o SendEnv=no -q -tt lpar2rrd@10.2.144.152

Your IP address is 10.2.12.167

Your UserName is lpar2rrd

CLI> show performance

Status    [ON]

Interval  [300sec]

CLI>

I tried the "echo | ssh" usage with start/stop performance, and it seems it isn't started/stopped, might be the echo doesn't even reach the eternus.

Chris

Pavel

Hi,

ok, I found out that this is probaly something we do not support.

Same issue has apparently even newer DX90S2.

We have no solution for that, ssh does not accept commands from its input.

We support DX500 S4/DX600 S4, the DX500 S3/ DX600 S3, DX8700 S3/DX8900 S3 and newer only.

cja

Thankyou for your answer