There is allways a Fabric_1 shown

jriemer

In san-list.cfg I configured 2 switches with Fabric_A and Fabric_B and some more without the fabric parameter:

172.nn.nn.1:xxx:BRCD:Fabric_A
172.nn.nn.2:xxx:BRCD:Fabric_B
172.nn.nn.3:xxx:BRCD:
172.nn.nn:4:xxx:BRCD:
...

In the gui (SAN-Switch->Totals->Fabric) Fabric_A and Fabric_B are shown and a Farbic_1 apears there too which I nerver configured anywhere? Anyone experience the same? Why is that Fabric_1 is shown? Where is it configured?? I use the virtual appliance..

Any ideas?

Karel

Hi,
can you send us logs?

cd /home/stor2rrd/stor2rrd # or where is your STOR2RRD working dir
find data -exec ls -ld {} \; > tmp/list_data.txt
ps -ef |egrep "2rrd|svc|xiv|ds8|ds5|hus" >> tmp/list_data.txt
cat data/*/fabric.txt >tmp/all_fabric.txt
tar cvhf logs.tar logs etc tmp/*txt # do not miss "h" option in tar
gzip -9 logs.tar

Send us logs.tar.gz via https://upload.stor2rrd.com

jriemer

logs.tar.gz is uploaded

jriemer

uploaded the screenshot too

Pavel

One switch did not have enabled all required MIBs.
Documentation has been enhanced about this:

When there is no data from the switch at all than check if it has allowed all SNMP MIBs
$ /opt/freeware/bin/snmpwalk -v 1 -c public <Switch_IP> 1.3.6.1.2.1.75.1.1.1
SNMPv2-SMI::mib-2.75.1.1.1.0 = Hex-STRING: 10 00 00 27 F8 6E 88 CD

When above cmd returns nothing then check MIB setup:
SAN1:admin> snmpconfig --show mibcapability
FE-MIB: YES
SW-MIB: YES
FA-MIB: YES
FICON-MIB: YES
HA-MIB: YES
FCIP-MIB: YES
ISCSI-MIB: YES
IF-MIB: YES
BD-MIB: YES
...
Activate all MIBs to get exactly above output:
SAN1:admin> snmpconfig -set mibcapabitily

jriemer

after changing the MIB settings, everthing works fine now