3PAR CLI

mostafa
mostafa
in HPE
Hi,
In the 3PAR installation section, you mentioned that we should have 3PAR CLI package for 3PAR 3.2.2 MU4 and higher. The package you mentioned was 3PAR_INFORMOS_3.2.2_MU4_CLI_SNMP_QR482-11192.iso. Is it OK if we use this one instead:
3PAR_INFORMOS_3.2.2_MU2_CLI_SNMP_QR482-11192.iso 

(MU2 instead of MU4)?



Comments

  • Pavel
    Pavel
    Hi,

    yes, that was only example.
  • Cyraxan
    Cyraxan
    edited October 2022

    Hello. I downloaded the fresh xorux 7.50 OVF, I am trying to install the 3PAR CLI to monitor 3PAR 7200 3.2.2 MU6 as described in https://stor2rrd.com/HPE-3PAR-MSA-XP7-NIMBLE-StoreOnce-monitoring.php and I ran into a problem.


    I installed the prerequisites (dnf install zlib.i686 glibc.i686 nss-softokn-freebl.i686 unzip), but the setup.bin fails with an error:

    [root@xorux linux]# ./setup.bin

    Preparing to install...

    Extracting the JRE from the installer archive...

    Unpacking the JRE...

    Extracting the installation resources from the installer archive...

    Configuring the installer for this system's environment...


    Launching installer...


    There was an error trying to initialize the HPI library.

    Could not create the Java virtual machine.


    As far as I understand, the JRE bundled with setup.bin (unpacks to /tmp/install.dir.5039/Linux/resource/jre/bin/*) is a issue, if i try to run

    "/tmp/install.dir.5039/Linux/resource/jre/bin/java --version" it says same


    There was an error trying to initialize the HPI library.

    Could not create the Java virtual machine.

    I tried both 3PAR_INFORM_OS_3.2.2_MU4_CLI_SNMP_QR482-11192.iso and 3PAR_INFORMOS_3.2.2_MU6_CLI_SNMP_QR482-11287.iso, no success.

  • Pavel
    Pavel

    Hi,


    your right, even we are unable to install 3par CLI on RHEL 8 based Linux. RHEL 7 is fine.

    We are in touch with HPE support ... will let you know late on.

    However you might try REST API access if your 3par firmware is not the historic one.

  • PeWu
    PeWu

    Hi,

    STOR2RRD 7.50 is running on Rocky Linux 8 (open-source linux distribution 100% compatible with RHEL 8).

    HPE 3PAR CLI 3.2.2 and 3.3.1 are not supported on RHEL 8. (The installation tool is using old version of Java.)

    You need HPE 3PAR Tools 3.3.2.

    Confirmed by HPE and tested (3PAR CLI 3.3.2 MU1 with STOR2RRD 7.50).

Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register

Categories

In this Discussion