Upgrade from 2.20 to 2.30

mbayard
mbayard
in STOR2RRD
Hi,

I upgraded from 2.20 to 2.30, everything went fine, but the Web Interface doesn't show the "Group by storage type" at the correct place, and the "New" buttons from "Reporter" section/tabs are not doing anything.

I tested on a fresh 2.30 and everything is fine ...

Upgraded :



Fresh Install :


Comments

  • Pavel
    Pavel
    can you try it in some other browser?
    It might be some browser caching issue.
  • mbayard
    mbayard
    I'll slap myself, you're correct ... Other browser is fine, and ctrl-f5 in first browser is fine too now :)

    Thanks again.
  • mbayard
    mbayard
    edited May 2018
    While looking to this problem, I also noticed in reporter.error.log :

    Thu May 24 15:44:30 2018: /home/stor2rrd/stor2rrd/etc/web_config/reporter.json does not exists! Exiting... : No such file or directory
    Thu May 24 16:15:19 2018: /home/stor2rrd/stor2rrd/etc/web_config/reporter.json does not exists! Exiting... : No such file or directory
    Thu May 24 17:15:17 2018: /home/stor2rrd/stor2rrd/etc/web_config/reporter.json does not exists! Exiting... : No such file or directory



    which indeed is not where stor2rrd is installed ... dunno if it's important :)
  • Pavel
    Pavel
    this file exists once reporter is configured.
    We should suppress that message if there is no reproter cfg yet.
  • mbayard
    mbayard
    Hi Pavel,

    I think I filled everything in the "Reporter" tabs and the configuration was saved :



    I created a report but when I tried to Save&Run :





    My stor2rrd instance is not located in the homedir of the stor2rrd user, can this be an issue ?

    Thanks.
  • Pavel
    Pavel
    ok, this is a bug
    to fix it:
    vi bin/reporter.pl

    remove line 13:
    $basedir         = "/home/stor2rrd/stor2rrd";


    Then it will work.


  • mbayard
    mbayard
    It works now, thanks B)
  • mrcpld
    mrcpld
    Hi All
    I have a problem with the update, after switching to 2.30, the tool continues to report an error on the asynchronous replicas between an SVC and V7000:

    STOR2RRD FlashCopy Error for device v7000,
    STOR2RRD FlashCopy Error for device svc,

    Actually we do not have any anomaly but it's just a mistake of stor2rrd snapshot alerting system.

    it's possible disable/exclude the Snapshot alerting in a specific storage?

    Why does the system recognize this replication mode as an error?
  • Pavel
    Pavel
    Hi,

    cd /home/stor2rrd/stor2rrd
    cat tmp/snapshotting-status/<storage name>.txt

    You can even send it to our support email


Sign In or Register to comment.

Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

Sign In Register

Categories

In this Discussion