Virtual Fabric Vision

Hello

General question about stor2rrd and VF

Installed STOR2RRD version7.95 for monitoring 620, configured , connection test Ok, use snmpv3

620 created 3 VF + default , each context has switchname and fabricname ; one IP in default context ( this IP created new SAN switch )

lscfg --show -n

-----------------------------------------------------------

Switch Information

-----------------------------------------------------------

FID: 128

SwitchType: DS

DomainID: 155

SwitchName: MAIN

FabricName: DEFCONT

-----------------------------------------------------------

FID: 24

SwitchType: LS

DomainID: 215

SwitchName: S4-M3-R27-Bottom-VM

FabricName: VM

-----------------------------------------------------------

FID: 2

SwitchType: LS

DomainID: 1

SwitchName: switch_2

FabricName: PROD

-----------------------------------------------------------

FID: 4

SwitchType: LS

DomainID: 1

SwitchName: switch_4

FabricName: S4-M3-TEST

-----------------------------------------------------------

ipaddrshow

SWITCH

Ethernet IP Address: 10.246.178.160

Ethernet Subnet mask: 255.255.255.0

Gateway IP Address: 10.246.178.1

DHCP: Off

In SAN configuration I select "VM" fabricname

As result after ./load/sh in left menu created SAN switch MAIN - that is default context switchname

But there are no others anywhere virtual switchname and fabricname . All ports all context visible .

In MAIN Configuration list correct port distribution between VF .

Is this the correct behavior stor2rrd or am I doing something wrong?

It would be desirable to see a list of all virtual switch .

WBR Andrew .